One of the major reasons for studying chemical kinetics is to use measurements of the macroscopic properties of a system, COA of Formula: C51H42O3Pd2, such as the rate of change in the concentration of reactants or products with time.In a article, mentioned the application of 52409-22-0, Name is Pd2(DBA)3, molecular formula is C51H42O3Pd2
Benzodithiophene and benzotrithiophene-based conjugated polymers for organic thin-film transistors application: Impact of conjugated- and acyl-side chain
A series of benzodithiophene (BDT) and benzotrithiophene (BTT)-based conjugated polymers (P1-P4), with/without conjugated- and acyl-side chain, have been synthesized by Stille cross-coupling reaction. Their thermal, photophysical, electrochemical properties, devices performances, and microstructure have been investigated. Conjugated-side chain can significantly raise the thermal stability and acyl-side chain can lower HOMO/LUMO energy levels. Organic thin-film transistors (OTFTs) based on conjugated polymers were fabricated and the transistor electrical characterization showed the device performance was sensitive to the conjugated- and acyl-side chain substituent of polymers. A maximum hole mobility of 1.70 ¡Á 10-3 cm2 V-1 s-1 was obtained for P1-based devices, which is an order of magnitude higher than those of P3 and P4-based devices. The corresponding microstructures were investigated by grazing-incidence X-ray diffraction (GIXD) to correlate with conjugated- and acyl-side chain dependent carrier mobility of P1-P4. The results showed that the conjugated- and acyl-side chain have an impact on the polymer packing models and device performances.
Sometimes chemists are able to propose two or more mechanisms that are consistent with the available data. COA of Formula: C51H42O3Pd2, If a proposed mechanism predicts the wrong experimental rate law, however, the mechanism must be incorrect.Welcome to check out more blogs about 52409-22-0, in my other articles.
Reference£º
Chapter 1 An introduction to palladium catalysis,
Palladium/carbon catalyst regeneration and mechanical application method